Triple string 12.6V lithium battery protection board, triple string 11.1V polymer 12V 100A split band balance

There are Chinese and English labels.
3 series of 11.1V high current 100A, 3.7V ternary lithium battery protection board with balanced charging.
The properties of the lithium battery protection board:
Model: HX-3S-F100A Overcharge voltage range: 4.28v ± 0.05v
Size: 70 * 60 * 8.5mm Overdischarge voltage range: 2.5 ± 0.05v
Upper limit working current: 100A (pay attention to heat dissipation) Working temperature: -40--+50 ℃
Upper limit instantaneous current: 100-120A Storage conditions: -40--+80 ℃
Static current: less than 30uA, effective life: greater than 30000 hours
Internal resistance: less than 300m Ω Short circuit protection: Protectable, delayed self recovery.
Balanced current: 65mA
Charging voltage: 12.6V-13V, upper limit of charging current: 10A
T-point explanation: Adding a normally closed temperature sensing switch can expand the temperature protection effect. The 0R resistor next to the solder joint should be removed.
Attention: For products with a discharge current of 3A or higher, the battery discharge rate should be above 3C.
Calculation formula for multiplication: For a 1C multiplication rate battery, the 2000 capacity is equal to 2AH * 1=2A working current.
A 3C rate battery with a capacity of 2000 is equivalent to a working current of 2AH * 3=6A.
When the battery heats up during use, it is because the battery rate is not suitable. This situation cannot be used for a long time, and the battery will be damaged quickly.
Attention 1: Strictly follow the diagram to wire 0V (B -), 3.7V (B1), 7.4V (B2), 11.1V (B+), C-charging negative, C+charging positive, P-output negative, P+output positive, do not intentionally short circuit!
Note 2: After connecting the wires, it is necessary to charge first before there is an output.
Note 3: When connecting three sets of batteries in series, please ensure that the voltage of each set of batteries is the same. If it is different, please fully charge each set of batteries separately before using them in series. The group of batteries with a fast voltage drop during discharge testing is a poor battery.
Explanation: Do not mix good batteries with poor batteries for use! The closer the capacity/internal resistance of 3 sets of batteries is, the better! (2 good batteries+1 poor battery usage effect=3 poor battery usage effect).
There are 10 MOS tubes, strong heat dissipation aluminum sheets, and a continuous current limit of 100A. Suitable for inverters, xenon lamps, solar street lights, and other 3 series of lithium battery packs.