- generator set, automatic battery charger, lead-acid battery, floating charger, BC245, 5A, 24V

BC243 switch type lead-acid battery charger with automatic charging, constant current, constant voltage charging mode, charging for constant current in the initial charge, strictly control the charging current, the battery is charging, charging the late charge for water floating, the battery voltage to maintain adequate long-term value, especially suitable for charging the battery standby generator set.

First, technical characteristics

Input voltage: 160~250V AC

Frequency: 50/60HZ

Charging power: BC245, 3A, 5A

The floating voltage: BC243 26V~29V adjustable

Factory settings 27.6V

Two, functional characteristics

1. can be used in humid environment of temperature -40 DEG C to +50 DEG C and relative humidity 98%RH is not dew.
2. may allow the battery to charge the battery and start the motor at the same time.
3. suitable for lead-acid batteries, especially for fully sealed solid wide temperature batteries.
4 constant current fast charging: when the battery voltage is lower than the set value (12V / 12V battery, 24V
Battery / 24V), with the constant current charger for battery fast charging.
5 current limit: when the battery is charged to full (12V battery 24V battery is more than 12V, more than 24V),
The charge stream is automatically Limited (characteristics such as Figure 1, constant voltage section).
6 floating: when charging the battery voltage reaches the set value (float 12V battery is about
13.8V 24V battery is about 27.6V), is automatically transferred to the floating state, which is about 0.1 ~ 0.2A
The current is charged (specifically related to the amount of electricity consumed by the power supply -).
7. stop charging: when the voltage of the charged battery reaches the filling setting value (12V is 14V, 24V is 28V), the charging output is automatically turned off.
8. over-current and short-circuit protection: the product has perfect over-current and short-circuit protection, because the product has constant
Flow characteristics, so when the battery capacity is large (the resistance is minimal), the load is short or during the mains charging
Start the motor at the same time (at this time the starting current is very large and close to the charger)
The short circuit will not damage either. At the same time, due to this characteristic of the product, when the battery is used as the starting point
The charger does not need to be disconnected when used.
9. automatically identify the voltage level of the charged battery pack and then charge automatically according to the battery voltage level.

10. aluminum shell, faster and better heat dissipation.

Two, matters needing attention

1. the input voltage shall not be greater than 265V AC (or 132V AC), otherwise the charger will be damaged.

The 2 charger has a - protection function, if the battery polarity - connection, battery charger internal self recovery fuse disconnect, disconnect the battery and connection, 10 minutes after the restoration of self recovery fuse conduction, the charger can continue to use.

Packing: white paper box

Size: 166*9540 (MM)

Weight: 0.47KG

.